Rifles Only is excited about the HAD (Heat Abatement Device) Suppressor Cover. This cover works for both heat abatement and mirage. The HAD is a two part cover with an inner core and a replaceable outer sleeve, which is a bonus, and can take more heat than Rifle Only's MAD cover. The inner core will take up to 3000 degrees sustained. The outer sleeve will take up to 2000 degrees and is interchangable so that you can change the cover to go with the environment in which you are in...or even whatever mood you are in. The outer sleeve will hold up to semi-auto fire, rapid fire, and full auto fire. We recommend that you do not get crazy on your Mag dumps. The weakest part of this higher heat rated cover is it's outer sleeve that wraps around the inner core, however it can take semi-auto, rapid fire and full auto fire, with it's 2000 degree rating. Something to keep is mind is the outer sleeve is the weakest point of the cover and can melt if you exceed it's heat rating, however your inner core will be fine, and you can purchase replacement outer sleeves separately, keeping in mind even your suppressor does have a heat limit before failure.
The HAD covers will fit suppressors from 1.3" up to 2" in diameter. (obviously a little more snug on the 2" as the inner core will stretch slightly to slide over up to a 2" diameter suppressor).
Once your HAD is installed you may need to re-tighten it after the first few uses as it can be stiff initially and hard to get tight and snug, however after use and "breaking it in" you can typically tighten the rope a little more to get it more snug. Please make sure to watch the installation video on Rifles Only's Website to ensure you've properly secured the cover to prevent any shifting during use, and re-tighten as needed once broken-in.
PLEASE MEASURE YOUR SUPPRESSOR BEFORE ORDERING. DO NOT USE THE MANUFACTURER SPECS OFF OF THE WEBSITE AS MANY TIMES THEY ARE END TO END AND INCLUDE THINGS YOU DON'T WANT TO COVER. IF YOU HAVE A QD MOUNT, OR A MUZZLE BRAKE/EXTERNAL BAFFLES AT THE FRONT, DO NOT INCLUDE THAT IN YOUR MEASUREMENT AS YOU DO NOT WANT TO COVER THOSE.
*NEVER ORDER A COVER THAT IS LONGER THAN YOUR SUPPRESSOR, not even by .1"**, always round down on cover size when you're inbetween sizes. You do NOT want any overhangs!
PLEASE NOTE: RIFLES ONLY'S WARRANTY WILL NOT COVER ANY SUPPRESSOR COVERS THAT ARE RUINED WITH A GUN LESS THAN 16" IN BARREL LENGTH.
