Due to the passage of AB 1621, we are currently unable to ship this product into California. Please do not place orders going to California. Orders placed with a shipping address in California will be canceled and subject to a restocking fee.
This item cannot be shipped to DC, New York, New Jersey, Hawaii, or Connecticut.
This AR10 Lower Receiver starts its' life as a Billet block of 7075 Aluminum. The block then goes to machining where it is turned into an 80% Lower with a fixed Trigger Guard. From there the mag wells are broached then they get sent to anodizing where they get a Type III hard coat anodized finish. High quality and available for a limited time! This Lower Receiver is compatible with DPMS patterned uppers. This LR308 Lower Receiver DOES NOT have the rear pocket cut. All machining processes have been completed and are within spec except for the following: 1. Milling out the receiver interior (Fire Control Cavity). 2. Cutting of the Trigger Slot (Trigger Through Hole) 3. Drilling of the Trigger Pin Hole 4. Drilling of the Hammer Pin Hole 5. Drilling of the Selector Hole Made of 7075 T6 Aluminium here in the U.S.A.
|Trigger Guard:||Built In Billet|
|Finish:||Depends on Customer Selection|